9 Volt Snap & Micro Push Button Switch For LED's

9 Volt Snap & Micro Push Button Switch For LED's w/8' wire The 1 Amp switch is a push-on, push-off switch. We have pre-connected the switch and battery strap, nothing left to do but connect your choice of LED lights. Yes! It really is just that easy! Twist the red leads on your lights with the red lead on this 12-inch battery snap. Protect the connection with tape or shrink tube. Then twist the black leads on your LEDs to the black lead on this snap. Again, protect the connection. Optional: to make your connections even stronger you can use solder on the connection joints Go! Snap on the 9 volt snap connector to any 9V DC battery. Press the locking switch and have a light show! Press again to turn it off. And you can connect A LOT of LEDs to this sturdy system. In our tests, 50 flashing LEDs shone nice and bright on a 9V battery for 4 1/2 hours. 3 LEDs were bright for 36 hours. If you are running less than 50 and more than 3, your run time per battery will be in the range between those low and high numbers. The battery snap with a switch can handle solid and flashing LEDs. There is no carryover flash. Up to 50 LEDs flashing, solid or both can run on one 9-volt battery. Dimensions Switch: 0.32 inches x 0.48 inches x 0.31 inches tall Strap: Black Lead 12" Red Lead 13" Switch is on red lead, 8.5 inches from the snap Leaving 4" after the switch free If you need more control, consider the battery snap with TWO switches! This double switch is great to individually control two different items, like a siren plus lights, or lights on different parts of a model or lights on different floors of a roombox. Refer to the diagram. 12-inch red wire 3.75 inch to the split each split has 4 inches to the switches 4 inches free after the switches.